IMPACT OF CUTTING MODES ON THE FORMATION OF TECHNOLOGICAL RESIDUAL STRESSES AT BLADE CUTTING

Authors

H.B. BAGHDASARYAN National Polytechnic University of Armenia Author
M.Y. HARUTYUNYAN National Polytechnic University of Armenia Author
V.H. BAGHDASARYAN National Polytechnic University of Armenia Author

Keywords:

blade cutting, cutting parameters, residual stresses, cutting temperature

Abstract

Issues on the impact of cutting modes on the formation of technological residual stresses in the subsurface layer at blade processing are considered. A brief analysis of the research results is carried out, appointment recommendations on the cutting modes are given at which in the subsurface layer, compressing residual stresses are accumulated.

Downloads

pdf

Published

29.06.2026

Issue

Section

Articles

Similar Articles

M.H. SAHAKYAN, H.S. SARAFYAN, ESTIMATION OF ECONOMIC EFFICIENCY OF INNOVATIVE TECHNOLOGIES IN GARMENT PRODUCTION CUTTING , Proceedings of Annual Conferences of NPUA: Vol. 2 (2017)
B.M. MAMIKONYAN, S.A. GHAZARYAN, INVARIANT MEASUREMENT OF THE PARAMETERS OF AN ACTIVE-INDUCTIVE BIPOLAR BY THE PHASE METHOD , Proceedings of Annual Conferences of NPUA: Vol. 1 (2023)
S.G. AGBALYAN, G.N. MELISETYAN, INFLUENCE OF THE TEMPERATURE RISE AT ONE BRAKING ON THE WEAR-RESISTANCE OF FRICTION MATERIALS , Proceedings of Annual Conferences of NPUA: Vol. 2 (2019)
A.S. ALAVERDYAN, R.R. VARDANYAN , G.H. KIRAKOSYAN, V.G. KHACHATURYAN, А REMOTE MONITORING SYSTEM FOR THE PARAMETERS OF SOLAR WATER - PUMPING STATIONS , Proceedings of Annual Conferences of NPUA: Vol. 1 (2018)
V.S. MELKONYAN, P.H. SHIRINYAN, A MICROCONTROLLER DEVICE FOR MEASURING THE TEMPERATURE OF THE THERMOCOUPLE WITH COLD-JUNCTION COMPENSATION , Proceedings of Annual Conferences of NPUA: Vol. 1 (2017)
H.R. DASHTOYAN, H.R. DASHTOYAN, V.V. BUNIATYAN, FABRICATION AND RESEARCH OF THE Au/BST/Au BULK CERAMIC CAPACITORS , Proceedings of Annual Conferences of NPUA: Vol. 1 (2017)
H.A. ISUNTS, MODELING A NEW CONSTRUCTION OF A FIXTURE FOR SHARPENING THE CUTTING EDGES OF A TWIST DRILL , Proceedings of Annual Conferences of NPUA: Vol. 1 (2022)
S.A. KYUREGHYAN, N.K. MANASYAN, INVESTIGATING THE TEMPERATURE IMPACT ON THE MECHANICAL PROPERTIES OF AMIDE YARNS , Proceedings of Annual Conferences of NPUA: Vol. 2 (2019)
A.V. DANIELYAN, CHARACTERIZING THE LATTICE PARAMETERS IN IRON-DOPED LITHIUM NIOBATE CRYSTALS WITH DIFFERENT STOICHIOMETRY , Proceedings of Annual Conferences of NPUA: Vol. 1 (2018)
L.S. AVANESOVA, JUSTIFYING THE METHOD OF COMPLEX RESEARCH OF THE RESIDUAL ORE STOCKS AT PROCESSED DEPOSITS BY THE GEOTECHNOLOGICAL METHOD , Proceedings of Annual Conferences of NPUA: Vol. 2 (2023)

Previous 21-30 of 153 Next

You may also start an advanced similarity search for this article.