THE IMPACT AND SOME WAVE PHENOMENA AT METAL CUTTING

M.M. SIMONYAN; V.R. GEVORGYAN

THE IMPACT AND SOME WAVE PHENOMENA AT METAL CUTTING

Authors

M.M. SIMONYAN National Polytechnic University of Armenia Author
V.R. GEVORGYAN National Polytechnic University of Armenia Author

Keywords:

interrupted cutting, stroke theory, elastic and plastic waves, measuring tract

Abstract

This work provides some insights into the theory of stroke and experimental results, which confirm the stroke availability during permanent cutting of metals.

Downloads

pdf

Published

06.04.2026

Issue

Vol. 2 (2020)

Section

Articles

Similar Articles

L.H. MUTAFYAN, R.E. AVAGYAN, THE IMPACT OF THE CUTTING CONDITIONS ON THE CUTTING TOOL WEAR AT TREATING HARD-PROCESSED MATERIALS AT INTERRUPTED CUTTING , Proceedings of Annual Conferences of NPUA: Vol. 2 (2017)
H.G. PEPELYAN, A.Z. AVETISYAN, INVESTIGATING THE POSSIBILITIES OF STRETCHING GENUINE LEATHER BEFORE THE CUTTING PROCESS , Proceedings of Annual Conferences of NPUA: Vol. 2 (2020)
H.S. CHIBUKHCHYAN, P.YU. GASPARYAN, RESEARCH OF IMPROVEMENT OF MECHANICAL PROPERTIES OF THIN-WALLED PARTS USED IN AVIATION TECHNOLOGY , Proceedings of Annual Conferences of NPUA: Vol. 1 (2022)
G.L. PETROSYAN, N.G. HAKOBYAN, A SIMPLIFIED METHOD FOR DETERMINING THE STRESSES ON FREE SURFACES OF A CURVED WIDE STRIP , Proceedings of Annual Conferences of NPUA: Vol. 2 (2019)
A.M. ARZUMANYAN, T.A. MIRVELYAN, CALCULATION OF CUTTING STRENGTH AT PROCESSING OF ALLOYS FROM NON-FERROUS METALS BY CORUNDUM CUTTING PLATES WITH SQUARE-CUTTING CUTTING LOOP , Proceedings of Annual Conferences of NPUA: Vol. 2 (2018)
H.B. BAGHDASARYAN , M.Y. HARUTYUNYAN, V.H. BAGHDASARYAN , IMPACT OF CUTTING MODES ON THE FORMATION OF TECHNOLOGICAL RESIDUAL STRESSES AT BLADE CUTTING , Proceedings of Annual Conferences of NPUA: Vol. 2 (2017)
B.A. BALASANYAN, A.L. ARSHAKYAN, S.H. HAKOBYAN, B.S. BALASANYAN, A PROGRAM FOR CALCULATING THE CUTTING DEPTHS OF THE STAGES OF A MULTI-STAGE DRILL FROM THE EQUALITY CONDITION OF THE PRODUCTS OF THEIR TORQUES AND AXIAL FORCES , Proceedings of Annual Conferences of NPUA: Vol. 1 (2023)
H.S. CHIBUKHCHYAN, G.S. CHIBUKHCHYAN, M.Y. ZAKARYAN, A ROBOT MANIPULATOR FOR COLLECTING THE DOMESTIC WASTE FROM WATER SURFACES , Proceedings of Annual Conferences of NPUA: Vol. 1 (2023)
L.S. ABRAHAMYAN, DESIGNING A CAPACITANCE MEASURING DEVICE USING THE PHASE-METRIC METHOD , Proceedings of Annual Conferences of NPUA: Vol. 1 (2018)
D.G. YURMUZYAN, G.A. SIMONYAN, INVESTIGATING THE CUTTING PROCESS WITH A MULTISTEPPED BLADE CUTTER THROUGH THREE-DIMENSIONAL MODELING , Proceedings of Annual Conferences of NPUA: Vol. 2 (2017)

1-10 of 103 Next

You may also start an advanced similarity search for this article.

THE IMPACT AND SOME WAVE PHENOMENA AT METAL CUTTING

Authors

Keywords:

Abstract

Downloads

Published

Issue

Section

Similar Articles

edtor