MODELING AND INVESTIGATING THE MICROROBOTS OF COORDINATE DISPLACEMENTS

N.KH. HAKOBYAN; M.G. HARUTYUNYAN

MODELING AND INVESTIGATING THE MICROROBOTS OF COORDINATE DISPLACEMENTS

Authors

N.KH. HAKOBYAN National Polytechnic University of Armenia Author
M.G. HARUTYUNYAN National Polytechnic University of Armenia Author

Keywords:

microrobot, elastic joint, coordinate displacement, stiffness

Abstract

A three-dimensional model is presented and the stiffness and kinematic characteristics of a microrobot with coordinate displacements, using the ANSYS program are investigated.

Downloads

pdf

Published

29.06.2026

Issue

Vol. 2 (2017)

Section

Articles

Most read articles by the same author(s)

S.D. GHAZARYAN, M.G. HARUTYUNYAN, DESIGN OF A PORTABLE ORTHOSIS FOR WALKING AND SITTING OF A HUMAN , Proceedings of Annual Conferences of NPUA: Vol. 2 (2018)
S.D. GHAZARYAN, M.G. HARUTYUNYAN, N.B. ZAKARYAN, YU.L. SARGSYAN, S.V. VERLINSKI, CONSTRUCTING AN ASSISTANT DEVICE WITH FLEXIBLE ELEMENTS FOR WALKING AND SITTING OF A HUMAN , Proceedings of Annual Conferences of NPUA: Vol. 2 (2020)
B.H. SHAHAZIZYAN, N.H. HAKOBYAN, M.G. HARUTYUNYAN, DESIGN OF ACTUAL STRUCTURES FOR EXOSKELETON SYSTEMS AND THEIR ACTIVE MODULES , Proceedings of Annual Conferences of NPUA: Vol. 2 (2018)
N.B. ZAKARYAN, M.G. HARUTYUNYAN, OPTIMAL DESIGN AND CONTROL OF A PLANAR MANIPULATOR USING THE THEORY OF DIFFERENTIAL GAMES , Proceedings of Annual Conferences of NPUA: Vol. 2 (2017)

Similar Articles

R.A. ATABEKYAN, Y.V. HARUTYUNYAN, FORMATION OF SEISMIC JOINTS IN BUILDINGS AND DISPLACEMENT ON SOFT SOIL SITES AT STRONG EARTHQUAKES , Proceedings of Annual Conferences of NPUA: Vol. 2 (2020)
A.V. ELOYAN, J.K. KARAPETYAN, OPTIMAL DESIGN OF ELASTIC BEAM STIFFNESS IN THE PROBLEM OF BEAM BENDING UNDER VARIABLE LOAD , Proceedings of Annual Conferences of NPUA: Vol. 1 (2025)
N.K. HAKOBYAN, S.V. VERLINSKI, OPTIMIZING THE GEOMETRIC AND HARDNESS CHARACTERISTICS OF PARALLEL MICROMANIPULATORS WITH ELASTIC JOINTS , Proceedings of Annual Conferences of NPUA: Vol. 2 (2018)
A.A. MARGARYAN, INVESTIGATING THE STRESS-STRAIN STATE OF PRINTING CYLINDERS IN THE CONTACT ZONE , Proceedings of Annual Conferences of NPUA: Vol. 2 (2017)
A.A. MARGARYAN, S.V. VERLINSKI, STUDYING THE STRAIN-STRESS STATE IN THE CONTACT OF PRINTING CYLINDERS BY THE METHOD OF FINITE ELEMENTS , Proceedings of Annual Conferences of NPUA: Vol. 2 (2018)
G.V. MUSAYELYAN, V.G. MUSAYELYAN, DEVELOPING CALCULATION MODELS FOR THE AUTOMOBILE LOAD-CARRYING SYSTEMS BY THE FINITE ELEMENT METHOD , Proceedings of Annual Conferences of NPUA: Vol. 2 (2018)
S.S. MARTIROSYAN, INVESTIGATION AND ANALYSIS OF PRESSURE AND DEFORMATION IN THE PRINTING ZONE , Proceedings of Annual Conferences of NPUA: Vol. 1 (2023)
G.V. MUSAYELYAN, V.G. MUSAYELYAN, G.S. YESAFYAN, PECUALIARITIES OF APPLYNG ADAPTIVE SUSPENSIONS IN CARS , Proceedings of Annual Conferences of NPUA: Vol. 2 (2020)
A.H. BAGHIYAN, DEFINING THE COORDINATES OF A TRACKED GROUND TARGET IN THE REFERENCE SYSTEM SK-42 ON THE AERIAL VEHICLES , Proceedings of Annual Conferences of NPUA: Vol. 1 (2017)
S.B. ANTONYAN, THE INFLUENCE OF ALTERNATING CURRENT AMPLITUDE AND FREQUENCY ON THE PROCESS OF THE COPPER COVERING FORMATION , Proceedings of Annual Conferences of NPUA: Vol. 3 (2018)

1-10 of 35 Next

You may also start an advanced similarity search for this article.

MODELING AND INVESTIGATING THE MICROROBOTS OF COORDINATE DISPLACEMENTS

Authors

Keywords:

Abstract

Downloads

Published

Issue

Section

Most read articles by the same author(s)

Similar Articles

edtor